Mitsubishi Outlander: Cleaning the interior of your vehicle
After cleaning the interior of your vehicle with water, cleaner or similar, wipe and dry in a shady, well-ventilated area.
CAUTION:
● Do not use organic substances (solvents, kerosine, alcohol, petrol, etc.) or alkaline or acidic solutions.
These chemicals can cause discolouring, staining or cracking of the surface.
If you use cleaners or polishing agents, make sure their ingredients do not include the substances mentioned above.
Plastic, vinyl leather, fabric and flocked parts
1. Gently wipe off with a sponge, gauze or other soft cloth soaked with a 3% aqueous solution of neutral detergent.
2. Dip cloth in fresh water and wring it out well. Using this cloth, wipe off the detergent thoroughly.
NOTE:
● Do not use the cleaners, conditioners, and protectants containing silicons or waxed.
Such products may cause annoying reflections and obscure vision.
Upholstery
1. To maintain the value of your new vehicle, handle the upholstery carefully and keep the interior clean.
Use a vacuum cleaner and brush to clean the seats. If stained, vinyl and synthetic leather should be cleaned with an appropriate cleaner. Cloth fabrics can be cleaned with either upholstery cleaner or a 3% aqueous solution of neutral detergent in lukewarm water.
2. Clean the carpeting with a vacuum cleaner and remove any stains with carpet cleaner. Oil and grease can be removed by lightly dabbing with a clean colourfast cloth and stain remover.
Genuine leather
1. Gently wipe off with gauze or other soft cloth soaked with a 5% aqueous solution of neutral detergent for wool.
2. Dip cloth in fresh water and wring it out well. Using this cloth, wipe off the detergent thoroughly.
3. Apply leather protecting agent to the genuine leather surface.
NOTE:
● If genuine leather is wet with water or is washed in water, wipe off water as quickly as possible with a dry, soft cloth.
● Slight stains on genuine leather may be removed with leather cleaner as well.
● The genuine leather surface may be damaged if a nylon brush or synthetic fibre is rubbed hard against it.
● Organic solvents such as benzine, alcohol and petrol, acid or alkaline solvents may discolour the genuine leather surface.
Be sure to use neutral detergents.
● Dirty genuine leather seat may mildew. Be very careful about oil stains and remove them quickly.
● The genuine leather surface may harden and shrink if it is exposed to direct rays of the sun for long hours. When your vehicle is parked, place it in the shade as much as possible.
● When the temperature of the vehicle interior rises in summer, vinyl products left on the genuine leather seat may deteriorate and stick to the seat.
READ NEXT:
Cleaning the exterior of your vehicle
If the following is left on your vehicle, it may cause corrosion, discolouration
and stains, wash the vehicle as soon as possible.
● Seawater, road deicing products.
● Soot and dust, i
Service precautions
Adequate care of your vehicle at regular intervals serves to preserve the value
and appearance as long as possible.
Maintenance items as described in this owner’s manual can be performed by the
SEE MORE:
DTC C100A, C1015, C1020, C102B, C1011, C101C, C1027, C1032, C1014,
C101F, C102A, C1035
DTC C100A: Abnormality in FL wheel speed sensor circuit
Wheel Speed Sensor Circuit
CAUTION
If there is any problem in the CAN bus lines, an incorrect
diagnostic trouble code may be set. Prior to this
diagnosis, diagnose the CAN bus lines.
Whenever ECU is replaced, ensure that the CAN bus
lin
Power Plant Mount
General Information
For the power plant support, the inertial axis
four-point mounting system is utilized, and the system
has the following features.
For the engine and transaxle mountings, the
cylindrical liquid seal mountings are used. This
reduces idling vibration and acceleration noise,
and
