Mitsubishi Outlander manuals

Mitsubishi Outlander: Headlamp washer switch

The headlamp washer can be operated with the ignition switch in the “ON” or “ACC”

The headlamp washer can be operated with the ignition switch in the “ON” or “ACC” position and the lamp switch at the Push the button once and the washer fluid will be sprayed on to the headlamps.position.

Push the button once and the washer fluid will be sprayed on to the headlamps.

NOTE:

● If the ignition switch is in the “ON” or “ACC” position and the headlamps are on, the headlamp washer operates together with the windscreen washer the first time the windscreen washer lever is pulled.

● Check the headlamp washers periodically to confirm that the washer fluid is being sprayed properly on to the headlamp lenses.

Precautions to observe when using wipers and washers

● If the moving wipers become blocked by ice or other deposits on the glass, the motor may burn out even if the wiper switch is turned to OFF. If obstruction occurs, park your vehicle in a safe place, turn off the ignition, and clean the deposits from the glass so that the wipers operate smoothly.

● Do not use the wipers when the glass is dry.

They may scratch the glass surface and the blades wear out prematurely.

● Before using the wipers in cold weather, check that the wiper blades are not frozen onto the glass. The motor may burn out if the wipers are used with the blades frozen onto the glass.

● Avoid using the washer continuously for more than 20 seconds. Do not operate the washer when the fluid reservoir is empty.

Otherwise, the motor may burn out.

● Periodically check the level of washer fluid in the reservoir and refill if required.

During cold weather, add a recommended washer solution that will not freeze in the washer reservoir. Failure to do so could result in loss of washer function and frost damage to the system components.

READ NEXT:

 Wiper deicer switch

The rear window demister switch can be operated when the engine is running. When the front wipers have frozen to the windscreen at the parked positions, turning on this switch will heat the winds

 Rear window demister switch

The rear window demister switch can be operated when the engine is running. Push the switch to turn on the rear window demister. It will be turned off automatically in about 20 minutes. To turn o

 Horn switch

Press the steering wheel on or around the mark

SEE MORE:

 Curtain Air Bag Module(s)

REMOVAL AND INSTALLATION WARNING Never attempt to disassemble or repair the curtain air bag modules. If faulty, replace it. Do not drop the curtain air bag modules or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust is detected. Do not expose the cur

 Radiator Grille, Moldings, Garnishes

Radiator Grille REMOVAL AND INSTALLATION Removal steps Headlight support panel cover Front bumper assembly Radiator grille Front-three diamond mark Headlight support upper panel cover Moldings REMOVAL AND INSTALLATION Pre-removal and Post-installation Operation Roof Rail Removal and I

© 2010-2025 Copyright www.mioutlander.com